In the process of operation, the soil.Spray machineDuring operation, it will encounter insufficient fuel inlet distance due to insufficient power. If the engine throttle valve is in a large position and the injection angle is appropriate, it is most likely that the pipeline is not smooth enough. At this time, the lower pipeline can be dredged. In addition, it can also be prevented by the following methods. Today, the sprayer manufacturer introduces:

1. Be careful not to put foreign matter into the fuel tank when loading the goods to avoid blocking the pipeline. For the mud spraying machine, if it is used for more than 1-2 years, the wear of the mud pump impeller will also cause insufficient spraying distance.

2. Clean the drainage pipe carefully after daily use.

3. When there are more foam stirring shafts in the stirring tank, the rotating speed can be reduced.

The stirring shaft speed is low, and the speed is low. The throttle valve still has no reflection. At this time, if the mixing shaft is in the proper position and the throttle valve is suitable, then:(1) the hydraulic oil will deteriorate and replace the hydraulic oil. (2) hydraulic pump failure. (3) hydraulic motor failure. (4) The mixed shaft debris is wound to clean the debris.

5. The main reasons for not spraying at the beginning are as follows: 1) The drain pipe is blocked and foreign objects can be cleaned. (2) There is air in the intake pipe, which can be opened and discharged. (3) shaft damage. If you need to replace the connector, please contact us. (4) The pump is stuck by foreign matter, do not rotate, take out the foreign matter. 5) The clutch is damaged. Please contact us to replace the clutch.

There are several types of sowing operation environments from June to October. The annual precipitation is about 800mm. The climate is hot and dry. After spraying in dry season, flowers, plants and trees can be irrigated manually by fog cannon vehicles. The slope of a gravel soil cutting slope is sufficient, the slope is 6.5 meters to 15 meters, the angle is 20 degrees to 37 degrees. The workbench width of this project shall not be less than five meters and more than twenty meters. A small number of high-steep and strong weathered rock slopes can reach 45 degrees, and the slope can reach about 35 meters.

The spraying machine shall be used in places where it is not convenient to cover soil, such as gravel cutting slopes, local high and steep slopes, and slopes with poor soil quality. There is also a small temporary slope. There is no need to find a slope greening construction unit to do it. One spray can achieve the effect of American engineering, restore ecology and reduce soil erosion.

Hunan Saner Heavy Industry Technology Development Co., Ltd. (hereinafter referred to as "Saner Heavy Industry") was established in 2010. Mainly engaged in the development and manufacture of high-tech intelligent equipment such as guest soil greening spraying machinery, concrete spraying machinery and mortar spraying machinery. Since its establishment, Saner Heavy Industry has been adhering to the vision of "technology wood priority, quality priority, progress assurance, and thoughtful service" to build the industry benchmark "Saner brand. The production and manufacturing base of Saner Heavy Industry is located in Saner Industrial Park, Economic and Technological Development Zone, Loudi City, Hunan Province. Under the leadership of Yidai Road, its products sell well in my country, and are exported to North America, Central Asia and Southeast Asian countries. Distributors in many countries have established cooperative relations and set up offices in Southeast Asia and Indonesia.