When the earth spraying machine is running, it will encounter the situation that the oil inlet distance is not enough due to insufficient power. If the throttle valve of the engine is in a great position and the spraying angle is appropriate, it is most likely that the pipeline is not smooth enough, and the lower pipeline can be dredged at this time. In addition, it can also be prevented by the following methods. Today, Saner Heavy Industry will introduce it:

1. Be careful not to put foreign matter into the fuel tank when loading the goods to avoid blocking the pipeline. For the sprayer, if it is used for more than 1-2 years, the wear of the impeller of the mud pump will also cause insufficient spraying distance.

2. Clean the drainage pipe carefully after daily use.

3. When there are more foam stirring shafts in the stirring tank, the rotating speed can be reduced.

The stirring shaft speed is low, and the speed is low. The throttle valve still has no reflection. At this time, if the stirring shaft is in the proper position and the throttle valve is suitable, then:

(1) Hydraulic oil will deteriorate and replace hydraulic oil.

(2) Hydraulic pump failure.

(3) Hydraulic motor failure.

(4) Wrap the mixed shaft to clean up the debris.

Do not spray after starting for the following reasons:

(1) The drain pipe is blocked, and the pipe can remove foreign matter.

If there is air in the intake pipe (2), the exhaust can be opened and discharged.

(3) Shaft damage. If you need to replace the connector, please contact us.

(4) The pump is jammed by a foreign object. Do not rotate it. Remove the foreign object.

No. 5) The clutch is damaged. Please contact us to replace the clutch.

There are several types of working environments for spraying machines from June to October. The annual precipitation is about 800mm. The climate is hot and dry. After spraying in dry season, flowers and trees can be irrigated by artificial spray using fog cannon vehicles. The slope of a gravel soil cutting slope is sufficient, the slope is 6.5 meters to 15 meters, the angle is 20 degrees to 37 degrees. The workbench width of this project shall not be less than five meters and more than twenty meters. A small number of high-steep and strong weathered rock slopes can reach 45 degrees, and the slope can reach about 35 meters. Spraying devices shall be used in places where it is inconvenient to cover soil, such as gravel cutting slopes, local high and steep slopes, and slopes with poor soil quality. There is also a small temporary slope. It is not necessary to find a slope greening construction unit to do it. One spray can achieve the United States and chemical engineering. Briefly describe the use of the spray sowing device, restore ecology and reduce soil erosion.

Hunan Saner Heavy Industry Technology Development Co., Ltd. (hereinafter referred to as "Saner Heavy Industry") was established in 2010. Since its establishment, Saner Heavy Industry has adhered to the vision of "technology wood priority, quality priority, progress assurance, and thoughtful service" to build the industry benchmark "Saner brand.

The production and manufacturing base of Saner heavy Industry is located in Saner Industrial Park, Economic and technological Development Zone, Loudi City, Hunan Province. Under the guidance of the first belt and road, the products sell well in China, and are exported to North America, Central Asia and Southeast Asian countries. We have established cooperative relations with dealers in many countries around the world, and set up offices in Southeast Asia and Indonesia.